The Auto Finesse Rejuvenate pre-wax cleanser is a glaze-based abrasive designed specifically to enhance the beauty and performance of our signature waxes.

Rejuvenate contains deep cleansing solvents, glazing oils and fine diminishing abrasives to remove stubborn contaminates, oxidation, and light swirling. The perfect base to apply wax.

Rejuvenate was designed for use with Auto Finesse's Carnauba Waxes, in order to create a striking concours-level finish for your car or motorcycle. However, it can also be used before applying Tough Coat paint sealant, in order to add more wax-like depth and richness. Rejuvenate can be applied by hand, dual-action, or rotary polisher. If you're a big fan of waxes, Auto Finesse Rejuvenate will become your new best friend.

500ml
Prepares surface before waxing
Enhances beauty and performance of waxes
Can be applied by hand or machine

Application:

Hand application: For hand application, we recommend using either a microfibre or dual foam applicator pad. Apply a small-coin sized drop of product to the applicator and work into the paint with light pressure until the residue turns clear. Use small, overlapping circular or linear motions when applying the product. For best results, confine yourself to working a small area at a time (No larger than 18 x 18 square inches). Once the product has been fully worked in, remove the residue immediately using a microfibre towel. For maximum gloss, or when working on very soft paint types, we recommend to use the black side of our dual foam applicator pad.

Dual Action Polisher: For application by Dual Action (DA) polisher, we recommend using a light foam finishing or polishing pad. Prime the pad with 2-4 pea-sized drops of product and spread onto a small area of the paint (no larger than 18 x 18 square inches) using the lowest setting on the machine. Afterwards, work the product in using slow, even overlapping passes, light pressure, and a moderate-high speed setting (4000-5000 OPM) until you see the residue starting to turn clear. At this stage, reduce the speed to its next lowest setting for another 2-3 section pass, and once again to its lowest setting for the final finishing passes. Just before the residue disappears entirely, remove it immediately using a microfibre towel. For maximum polishing performance, or when working on harder paint types, we would recommend a slightly firmer foam polishing pad.

Rotary Polisher: For application by Rotary Polisher, we recommend using a light foam finishing or polishing pad. Prime the pad with 2-4 pea-sized drops of product and spread onto a small area of the paint (no larger than 18 x 18 square inches) using the lowest setting on the machine. Afterwards, increase the speed to a maximum of 1200RPM until you see the residue starting to turn clear. At this stage, reduce the speed to its next lowest setting for another few section passes, and once again to its lowest setting for the final finishing stage. Just before the residue disappears entirely, remove it immediately using a microfibre towel. For maximum polishing performance, or when working on harder paint types, we would recommend a slightly firmer foam polishing pad.